Midi Gel Tank Agarose 10x15cm

Labpro Scientific’s 100% Aust. Made Electrophoresis Gel Tank (10x15cm) is a general purpose unit for both extended high-resolution linear runs as well as economical quick screens. The LP11000 is constructed of durable acrylic, which will withstand high voltages and extreme temperatures without cracking or warping, unlike most molded units. The LP11000 can be transformed into a quick screening unit with samples resolved in just 30-60 minutes. Resolution of restriction digestions, plasmid purification, and ligation reactions are all possible with short runs. The LP11000 is also compatible with a number of analytical and preparative combs for virtually every horizontal electrophoresis application.

SPECIFICATIONS

Height Width Length
Unit Dimensions: 7.0cm H x 16.5cm W x 30.5cm L
Gel Dimensions: 10.0cm x 15.0cm

CAPACITY

Maximum Sample Capacity: 80 Samples (4 Combs, 20 Samples Ea.)
Buffer Capacity: 500ml
Distance Between Electrodes: 27.0cm
Maximum Voltage: 200V

ORDERING INFORMATION
CATALOG# DESCRIPTION

LP11000 - ELECTROPHORESIS SYSTEM
(10X15CM) *Comes complete
with vented lid, UVTP casting
tray, 2 combs fixed height (1 x 15 & 1 x 20 tooth 1.5mm thick),
and power cords.

ACCESSORIES AND REPLACEMENT PARTS
CATALOG# DESCRIPTION

LP11021 - LP11000 UVPT Casting Tray
LP10500 - Replacement Power Cords
LP11201 - Replacement LP11000 Tank
LP11301 - Replacement LP11000 Lid
LP11305 - Replacement LP11000 Electrode Assembly
LP10505 - Replacement Tank Connector Kit


ADDITIONAL COMBS AVAILABLE
CATALOG# DESCRIPTION WELL VOLUME WIDTH PER SAMPLE


LP11060 - 1.5mm x 20 tooth 4.7mm 4.7μl
LP11045 - 1.5mm x 12 tooth 2.8mm 2.8μl
LP11050 - 1.5mm x 15 tooth 2.2mm 2.2μl
LP11055 - 1.5mm x 16 tooth 5.8mm 8.7μl
LP11060 - 1.5mm x 22 tooth 5.0mm 7.5μl
LP11065 - 1.5mm x 27 tooth 4.0mm 6.0μl
LP11070 - 1.5mm x 33 tooth 3.0mm 4.5μl
LP11075 - 1.5mm x 36 tooth 2.3mm 3.5μl

The LP11000 is designed for multipurpose electrophoresis. The maximum suggested applied voltage for the electrophoresis of DNA in agarose gels using the LP11000 is 140 volts. In a 1%TBE gel this translates into a run time of approximately 1 hour. Lower voltages may be used, of course, and as a general rule a 70 volt run will take twice as long as a 140 volt run. Higher voltages may be used to decrease run time. However, if the unit is being operated at higher voltages than 140 volts the heat generated during electrophoresis may decrease sample resolution. Such artifacts may be avoided by running the unit in a cold room, recirculating buffer, or adding 1X electrophoresis buffer “ice cubes” to keep the unit properly cooled. The suggested run parameters for the electrophoresis of RNA in agarose gels containing formaldehyde is 60-80 volts